![]() Once a problem has been determined to exist, use the total accumulated amount of the three Duval Triangle gases and plot the percentages of the total on the triangle to arrive at a diagnosis. If there is a sudden increase in H2 with only carbon monoxide and carbon dioxide and little or none of the hydrocarbon gases, we need to determine if the cellulose insulation is being degraded by overheating.Ģ. The L1 limits and gas generation rates from table on Picture 2 are more reliable than the IEEE® method however, one should use both methods to confirm that a problem exists. To use this table without the IEEE® method, at least one of the individual gases must be at L1 level or above and the gas generation rate must be at least at G2. At least one of the hydrocarbon gases or hydrogen must be in IEEE® Condition 3 and increasing at a generation rate (G2), from table shown on Picture 2, before a problem is confirmed. First determine whether a problem exists by using the IEEE® method above, and/or table shown on Picture 2 below.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |